Screw
the pipe and regulator assembly into the heater head. Point
the adjustment screw on the regulator to the front of the
heater. Only Natural gas models are supplied with a regulator
for LPG models the pipe screws straight into the bottom of
the heater head.
Step
2
Fit
the pole over the pipe assembly and using the screws supplied
fix the pole to the heater head. Make sure the regulator adjustment
lines up with the hole in the pole.
Step
3
Concrete
the pole into the ground to a depth of 450mm.
Step
4
Fit
the reflector to the heater head.
Step
5
Test
fire the heater and test the gas pressure at the test point
on the gas valve. Check for gas leaks.
The
Ozglow F40 patio heater is for use with Natural or Propane gas.
Gas pressure details are on the appliance data plate fitted above
the gas valve.
This
Ozglow heater is to be installed to the requirements of all local
gas authorities.
This
Ozglow heater must have the following clearances from combustible
materials: 300mm above, 600mm at the sides and 2000mm below. For
all other installation requirements refer to code AG 601- gas
installations.
Overall
height 2370mm, overall width 890mm.
This
Ozglow heater is for outdoor installation only. An outdoor area
is defined as:
With
walls on all sides but with no overhead cover
Within
a partial enclosure that includes an overhead cover and no more
than 2 side walls. These side walls may be parallel, or at right
angles to each other.
Within
a partial enclosure that includes an overhead cover and 3 side
walls, as long as 30 percent or more of the walls forming the
partial enclosure is open and unrestricted.
This
Ozglow heater is to be placed on level, stable surfaces.
This
Ozglow heater should be inspected before each use. Particular
attention should be given to the hose assembly to make sure there
is no signs of damage or wear and tear.
This
Ozglow heater should be checked at least once a year by a qualified
service person.
Keep
this Ozglow heater free of cobwebs and in as dust free an area
as possible.
If
the flame becomes excessively long and yellow or if soot builds
up on the emitter mesh turn the heater off and call a qualified
service person.
If
this ozglow heater will not light or operate normally contact
your local authorised service agent or your local gas authority.
When
this Ozglow heater has been assembled follow the lighting instructions
on the data plate and test the heater operation. On the first
light up or when the bottle has been changed it may take several
minutes to purge the air from the pilot line.
Some
smoke may appear around the emitter screen and reflector for the
first minute or two of the initial light up.
To
light the pilot
1.
Depress the control knob and rotate anti clockwise to the pilot
position
2.
View the pilot through the pilot hole near the burner
3.
Hold the knob in the pilot position until the pilot has been alight
for 15 seconds. If the pilot does not light repeat steps 1 - 3
To
turn heater on
Rotate
the knob anti clockwise from the pilot position to either the
high or low positions.
To
turn heater off
Rotate
the knob clockwise to the pilot position. If you rotate the knob
fully clockwise the pilot will also turn off.
